Ussuray 746P06431 Throttle/Choke Cable Replacement For Cub Cadet Xt1 Xt2 Slx54 Gx54 Gx50 St54 Lawn Mowers 746-06431

Description

746P06431 Throttle Choke Cable Compatible With Cub Cadet Enduro Lawn Mowers Xt1-Gt50 Xt1-Gt54 Fab Xt1-Lt46 Xt1-Lt50 Fab Xt1-St54 Fab Xt2-Gx50 Fab Xt2-Gx54 Fab Xt2-Slx54 Fab Lawnmower Throttle Cable Replacement And Adjustment ? Step 1: Remove The Old Throttle Cable:Turn Off Your Lawnmower And Take Off The Old Throttle Cable By Removing The Cable Casing With A Pair Of Needle-Nose Pliers. Free The Throttle Cable From The Throttle Arm By Opening The Unit And Pull And Removing The Lock Screws On The Handle. Pull Out The Freed Throttle Cable. ? Step 2: Place New Cable On The Handle:Place The New Throttle Cable On Your Mowers Handle. Look At The Engines Back For The Wire Base. Insert The Cable Through The Base And The Throttle Arm. When Installing The New Cable On Your Lawnmowers Handle, You May Need To Drill New Holes If There Arent Any Holes Already And A Bolt To Fasten The New Cable. ? Step 3: Connect The New Cable: Calculate The Size Of The Cable And Give It An Extra Inch For Allowances. The Allowance Will Also Make The Cable A Little Loose, Allowing The Handles To Be Folded Down.Slip The New Cable Through The Housing And Fasten It To The Throttle Handle. The Cable Should Be Tight Enough For You To Have The Throttle Down. Tighten The Lock Screw And Reinstall The Housing. ? Step 4: Adjust The New Cable:Once The Old Cable Has Been Replaced, You Need To Adjust The New Throttle Cable Based On Your Mowers Behavior. For This Purpose, Restore The Throttle To Check If The Tension Is Right. Now Turn On The Mower. If The Mower Is Running Too High In Idle Status, It Means That The Cables Tension Is Too Much, And The Cable Needs To Be Loosened. ? Step 5: Test Drive:Once The Replacement And Adjustment Are Made, Try Your Mower And See If All Works Fine. If Everything Works Fine, It Means That The Replacement Has Been Done Successfully.